TILT-UP TOWERS

TOWER TUBE COUPLERS slip inside the tower pipe/tube to make one long tower unit. Flanges welded to the couplers are the guy cable attachment points. Couplers are included with all tower packages.

















The TOP GUY BRACKET slips over the top piece of tower tube/pipe and is positioned just below the blades of the wind generator. This bracket is included with all tower packages.

EQUALIZER PLATES attach the guy wires to the anchors using thimbles and cable clips. The optional turnbuckle kit makes tower installation quicker. Equalizer plates are included with all tower packages.


TOWER TUBE/PIPE in 20' - 24' sections make up the body of the tower. Tower tube/pipe only included with the complete & galvanized tower packages.

PIVOT PLATES bolt to the gin pole and bottom tower tube/pipe to create the tower tilting "hinge". Pivot plates are included with all tower packages.


The GIN POLE is made of the same material as the body of the tower and is only included with the complete & galvanized tower packages.
GUY CABLES & HARDWARE are galvanized or coated for corrosion resistance. All cables & hardware are included with all tower packages.

The GIN END BRACKET slips into the end of the gin pole and attaches to the front anchor. The optional pulley kit cable that is used to raise and lower the tower is attached at this point. The gin end bracket is included with all tower packages.

The CENTER ANCHOR is directly under the tower while the FRONT, REAR & 2 SIDE ANCHORS create the four guy cable stations. The guy radius tells the distance between these four anchors and the center anchor. All anchors are included with all tower packages.

TUT HOME | ABOUT | PRICES | OPTIONS | HOME